SkyZone has forged a reputation of quality and reliability and has been tested and developed by FPV pilots for FPV pilots.

The Skyzone FPV 500-SET was configured from the ground up to be plug and play, all cables are pre-made with matching connectors, so no soldering or guesswork is required. The set is so complete even a “Y” power splitter is included for powering the video receiver and a set of goggles or a monitor off a single XT60.

The set includes the TS58500 transmitter, and this little gem packs 500mW of ultra clean 5.8GHz power in a micro sized video/audio TX. Great for those looking to save size and weight while still getting great performance. The TS58500 is transmitting a full range of 32 channels and only weighs 19g. And the Plug-n-Play set includes not only a match cable set for the included Sony CCD camera but also cables for the GoPro as well. For power the cables have mini JST connectors and a battery balance port power adapter.

At the heart of the set is the RC832 Receiver, it is nice and small in size, great for easy integration into your ground station or DIY goggles, but big in quality and features. The receiver uses the same two button interface, making channels swapping a breeze. There are two independent A/V outputs for both audio and video. So you can use a monitor and a set of goggles or maybe a DVR to record your flight. The receiver comes with 2 power cable options for mini JST or “Y” XT60 for receiver and monitor/goggle power.

To finish the Plug-n-Play set off a Sony FPV tuned 700TVL CCD camera is included with all matching cables and a set of 5.8GHz Circular polarized antennas for maximum performance. This set will get you FPV flying in no time, and a perfect match to the Quanum DIY goggles for a budget minded complete set.

Features:
• Plug-n-Play connection no soldering required
• Circular Polarized Antenna set included(LHCP)
• 32 channels: Cover A, B, E bands and F bands
• Two switching buttons for the band and channel with LED display on VRX
• Power off memory for last channel and band
• dual Independent video and audio signal outputs
• Micro sized 500mw VTX - perfect for use with small models
• 32 channels: Cover A, B, E bands and F bands
• Transmitter frequency: 5645-5945MHz with 500mW power output
• Long range transmitting distance
• 700TVL Sony CCD FPV camera

TS58500 V2 VTX Specs:
Modulate: Wideband FM Modulate
Power: 500mW
Video Format: NTSC/PAL
Output Impedance: 50 Ohm
Output Power: 26~27dBm
Channel: 32CH
Operating Voltage: 7V~24V
Supply Current: 220mA
Audio Carrier Frequency: 6.5MHz
Connector: RP-SMA
Dimension: 42mm x 23mm x 8mm
Weight: 19g (without antenna)

RC832 Receiver Specs:
Antenna connection: RP-SMA
Power input: 12V
Antenna impedance: 50Ω
Rx sensitivity -90dBm
Video impedance: 75Ω
Video format: NTSC/PAL auto
Dimension: 80x 65 x15mm

Camera Specs:
Sensor: 1/3 Sony 960H CCD
Resolution: 700TVL
Illumination: 0.01lux
Power: 7~13v (3s)

Antenna Specs:
Polarization: left hand (LHCP)
dbi gain: 1.5

Included:
TS58500 5.GHz 500mW 32CH A/V transmitter
RC832 32CH Video receiver
30x30mm 480TVL Sony CCD camera
Circular Polarized antenna set (LHCP)
GoPRO USB to A/V cable (for using GoPRO as A/V input)
Plug-n-Play cable set for camera and VTX
XT60 power Y Wire set for receiver and goggles
Standard power wire set
A/V Cable set (RCA)
Standard wire lead
Balance plug to JST for CAM/VTX power
Spare DIY A/V cables

Frequency range:
FR1 5865,5845,5825,5805,5785,5765,5745,5725
FR2 5733,5752,5771,5790,5809,5828,5847,5866
FR3 5707,5685,5665,5645,5885,5905,5925,5945
FR4 5740,5760,5780,5800,5820,5840,5860,5880
※ 当商品は国外でご使用されるお客様及び無線免許取得者向けに販売致しております。
動作テスト時には必ずアンテナを装着してから行ってください。
絶対にアンテナを外してのテストは行わないで下さい。壊れる事になり保証対象外です。
取り寄せ品の為１０日ほどでお届け」